With this round table, you can easily engrave rings, thread milling, etc.
- Secure workpiece holder with steel three-jaw chuck.
- Zero point defined by reference switch.
- As a counter bearing tailstock is used.
- Ready for our S300 and S400,S600, but also for other machines.
Specifications:
Three jaw chuck Used for concentric clamping.
Made from steel and offering 1.5 to 32mm and 12 to 65mm when reversing the jaws.
- Spindle Height / Finish: 32 mm
- Total height: 55 mm
- Width: 42 mm (without shaft)
- Reduction ratio: 54:1
- Sixteenth-step operation: 172,800 Steps/Umdrehung.....480 Steps / Step 8 ° .... = 1min ...... 1Step = 7.5 sec
- Runout accuracy: 0.01 mm
- Stepper motor: Nanotec 3.0 A 1.8 °
- Body: Aluminum 7075 - Almost game free running
- Very stable storage
- All rotating parts made of stainless steel
- Horizontal and vertical installation possible
- Fastening with 2 screws M6
Scope of delivery:
- Complete round table including three-jaw chuck
- Fixing screws for horizontal mounting
- Cable length 50 cm
- 9-pole Sub-D connector plug, suitable to our 4th axis module