With the Automatic Tool Changer for STEPCRAFT milling spindle MM-1000, Kress spindles type 530 FM, 800 FME, 800 FME-Q and 1050 FME-1 and AMB 800 FME a time consuming manual exchange of tools is no longer required. After once defining the parameters in the machine control software, the magazin is approached automatically. By use of compressed air, a tool is returned or a new one collected. The supplied magazine can hold up to six tools and is optionally extendable for up to twelve.
The Tool Changer can be operated with the Switch-Box. To use the Tool Changer, a compressor with minimum 9-10 bar (130 - 145 psi) is needed.
Tool holder with appropriate ER11 collets have to be purchased separately as well as the Switch Unit which is needed for operating the MM-800 / MM-1000.
Not suitable for AMB 1050-P / 1400 FME-P DI !
If you want to use the Tool Changer on your 1st generation STEPCRAFT D-Series, please contact us before buying.
Technical Specifications:
- SK 15 tool holders for ER11 collets from 1 to 8 mm
- Double ball bearing (sealed)
- Suitable for speeds up to 30.000 rpm
- Operating pressure: 8 bar
- Shaft diameter: 43 mm
- Diameter: 56 mm
- Length (without tool holder): 100 mm
- Weight: 585 g
Scope of Delivery:
- 1x Tool Changer
- 1x Magazine to hold up to 6 tools
- Wrench
Note
Saftey Reg
To Operate Auto Tool changers , All machines should be in an enclosure.
"please make sure you have protection against accidental tool ejection in your controller"