Long neck angle milling/drilling unit LWB/E

Long neck angle milling/drilling unit LWB/E

With a set of gears running on several ball bearings in a stable, die-cast aluminium housing head. Also suitable for right-angled separation of rods. With a special balanced, powerful, quiet and long-lasting DC motor. Infinitely variable rpm (full wave electronics). Main housing is made of glass-fibre reinforced POLYAMIDE. Safely stored in an attractive and extremely stable case made from high-grade polypropylene. With MICROMOT hardened steel collets (1.0 - 1.5 - 2.0 - 2.4 - 3.0 and 3.2mm).

Technical data:
220 - 240V. 100W. 3,000 - 15,000rpm. Length 270mm. Weight 550g. Insulated to class 2.

NO 28 492



MICROMOT steel collets
As described below. For all handheld MICROMOT machines, excluding the Engraver GG 12. One each 1.0 - 1.5 - 2.0 - 2.4 - 3.0 and 3.2mm, clamping nut and holder for storage are included.

NO 28 940



Note:
MICROMOT steel collets are hardened and thus have a high, consistent flexibility. They also maintain prolonged accuracy, even after regular use (these colletsshould not be compared with unhardened, fourslit collets of brass and aluminium). The triple slit collet is substantially more difficult to manufacture than the four-slit type,  but offers a better load-bearing surface. This is especially important for cutters with small shaft diameters.

Replacement Sanding Discs for the MICROMOT quick-change system (diameter 25 mm). È Aluminium Oxide (for steel)               NO 28 786 40 grit 5 pieces NO 28 787   80 grit   5 pieces   NO 28 788   180 grit   5 pieces                 Zircon Corundum (for working with stainless and alloy steel)               NO 28 789   50 grit   5 pieces   NO 28 790   80 grit   5 pieces   NO 28 791   120 grit   5 pieces                 Polishing Fleeces (for cleaning and polishing)               NO 28 792   rough   5 pieces   NO 28 793   fine   5 pieces   NO 28 794   extra fine   5 pieces

Storage case of high-grade polypropylene. Attractive design, very sturdy and large enough to put the machine back in the case after completing work, without having to "fumble". A label on the side identifies the contents.